The middle of the spring season is the peak time for cottage work. Because you’ve got to make up for all winter, that might mean a trip up to the roof. Cottage country is often a windy place, and that can mean torn asphalt roof shingles.
- Start repairs with a thin-bladed pry bar, lifting the edges of neighbouring shingles held down by tar.
- Bend back the shingle above the damage zone, remove the remains of the dead shingle as far up as you can reach, then pull out visible nails.
- The new shingle won’t slide into place far enough without trimming, so slice two inches off its back edge for a start. Give it a try. Slice more if needed.
- Secure new shingles with blobs of roofing tar from a caulking gun, top surface and bottom.
Black Pipe Essentials
Without black polyethylene pipe, cottagers everywhere would be hauling water with buckets. It’s the workhorse of backwoods plumbing systems because it’s inexpensive and tough. But there are also several important tricks for making tight connections with black poly pipe.
- Simply slipping black poly over matched fittings and then tightening down a screw clamp isn’t reliable. The connection will almost certainly leak. The key to water tight connections is heat.
- Slide two loose screw clamps over your pipe.
- Warm it gently with a propane torch.
- Then slip the poly over the fitting and torque down the clamps with a socket wrench while things are still warm. You’ll get water tight results, once and for all.
Every wood stove in cottage country is connected to at least a few pieces of black stove pipe. The safest installations include screws securing each pipe joint.
- A handful of #10 x 1/2-inch pan head screws, a red-handled Robertson screwdriver and a drill with a sharp 1/8-inch drill bit are all you need.
- Connect your stove to its chimney with black pipe and then drill three screw holes through the overlap at equal points around the perimeter.
- Torque the screws home and you’re done.
- The coarse thread of the #10 screw resists stripping as pipes are removed and replaced for cleaning.
An hour of work each spring or two ensures that rot won’t become an issue on decks and foundations at your cottage. All it takes is a $30 pump-up weed sprayer and a jug or two of clear, zinc-based wood preservative. It’s perfectly safe when used properly outdoors.
- When the weather dries up, don safety goggles and gloves.
- Spray preservative on areas of wood-to-masonry and wood-to-wood contact.
- Mark the sprayer for this use only and never spray anywhere near water courses.
- Even if you can’t get liquid right onto the wood-to-wood contact surfaces, spray around the edges. It’ll wick into all nooks and crannies, halting rot in its tracks.
Lots of people know that melting the ends of synthetic rope stops fraying, but things can frazzle badly right after a cut. This is especially true with braided nylon rope, which unravels faster than picnic plans in a thunderstorm.
- The trick is to wrap masking tape where you want to make the cut.
- Snip the rope in the middle of the tape.
- Then melt the ends and let them cool before peeling the tape off. Nothing could be neater.
Nobody buys a cottage because of the chores, but getting them done offers a kind of satisfaction that’s hard to match in the city!